Refill Oil
8. Remove dipstick (A), wipe clean and re-insert
it fully.
9. Refill with an approved oil between the two
marks on dipstick.
CAUTION:
After changing the oil and the
filter, ensure that the engine will
not start and operate the starter
motor until oil pressure is
obtained, waiting for 5 bar oil
pressure light to go out. To
ensure that the engine will not
start, disconnect the electrical
stop control of the fuel injection
pump. Run the engine and check
for leaks, then recheck the oil
level and top up if necessary.
The valves clearance should be
checked by your dealer or agent
every 1200 hours.
WARNING:
Engine oil, filter and fuel filters need to be changed every 200 hours when using BIO-
FUELS.
IMPORTANT:
When the Oil filter replacement is done, reset the oil change counter on display, as indicated on the
relative section of the manual.
GUID-5D7169FE-55C6-471C-B65A-729568D661C5-low.png [Low]
Fig. 118
4.12.21 Replace transmission/hydraulic oil filter cartridge
Before starting the procedure
For replacing the transmission oil filter element proceed as follows:
Procedure
1. Disconnect the Battery.
2. Arrange a suitable container for collecting the
hydraulic oil.
3. Unscrew the hydraulic filter bowls (A) and (B)
using a filter wrench.
4. Remove the filter cartridges (C) and (D).
5. Properly clean the filter bowls (A) and (B) and
their seats.
6. Apply a film of oil on the gaskets.
7. Install new filter cartridges (C) and (D).
8. Refit the filter bowls (A) and (B), and tighten
to 70 Nm.
9. Reconnect the Battery.
10. Run the engine for several seconds.
GUID-AC9E5ED6-17B7-46D4-8FB2-164731D3BDBD-low.png [Low]
Fig. 119
GUID-2AF3DC5F-A0F4-418D-80A6-3C86D27ABAC1 [V1]
4. Maintenance
204 F Series
39940211 (555124)
To Next Page
Loading...
Need help?
General
