Vertiv Netsure User Manual

NetSure
™
Control Unit (NCU)
User Manual, UM1M830BNA
Spec. No: 1M830BNA, 1M830DNA Code: UM1M830BNA
Model No: M830B, M830D Revision M, May 12, 2017
[196]
TL1 Autonomous Message Sample
The DI1 alarm occurs.
When the alarm occurs, the controller sends this autonomous message:
LorainLab 15-09-24 13:49:42
*C 8 REPT ALM EQPT
"PowerSystem:CR,Alarm,SA,09-24,13-49-41,,,0,0,0-MIN:\"DI1 Alarm\","
;
<
When the alarm clears, the controller sends this autonomous message:
LorainLab 15-09-24 13:50:06
A 9 REPT ALM EQPT
"PowerSystem:CL,Alarm,SA,09-24,13-50-06,,,0,1,0-MIN:\"DI1 Alarm\","
;
<
TABLE OF TL1 COMMANDS SUPPORTED
Refer to Table 8 for a list of all TL1 commands supported, with a short description of each command.
Table 8. TL1 Commands Supported
TL1 Commands Supported
Description
ACTIVATE-USER
ACT-USER
Sets up a session with the system (i.e., logging into the system).
CANCEL-USER
CANC-USER
Terminates a session with the system (i.e., logging off of the system).
RETRIEVE-ALARM
RTRV-ALM-{EQPT|ALL}
Instructs the system to send the current state of its alarm conditions
associated with one or more equipment units, facilities, etc. within the
system.
RETRIEVE-EQUIPMENT
RTRV-EQPT
Instructs the system to send the current controller software version and
the controller software configuration part number and revision.
RETRIEVE-HEADER
RTRV-HDR
Requests that the system reply with a "normal" response indicating
COMPLD.

Vertiv Netsure Specifications

General

Brand	Vertiv
Model	Netsure
Category	Control Unit
Language	English