– Insert this pin in holes in lower transverse link -arrow-.
– Then insert top spring seat into upper end of spring.
– Release tension on spring while locating upper spring seat on
lug on body.
– Remove spring compressor.
– Install wheel and tighten ⇒ page 288 .
5.2 Removing and installing shock absorb‐
ers
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Removing
– Remove wheel.
– Remove wheel housing liner ⇒ General body repairs, exterior;
Rep. Gr. 66 .
– Remove coil spring ⇒ page 173 .
– Remove bolts -arrows-.
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
5. Assembly overview: shock absorber, coil spring (front-wheel drive) 175