3.10 Repairing subframe (four-wheel drive)
Special tools and workshop equipment required
♦ Assembly tool -T10214-
♦ Assembly tool -T10244-
Pressing out bonded rubber bush
– Remove subframe ⇒ page 21 .
– Press out both bonded rubber bushes at the same time as
illustrated.
Note
♦
Chamfer of thrust piece -T10214/3- must point up.
♦
Tube -T10244/3- has a larger and a smaller internal diameter.
The subframe must lie against the larger internal diameter of
the tube -T10244/3-.
Pressing in bonded rubber bush
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
3. Subframe, anti-roll bar, suspension link 31