OM ET18/20/24 us 1.3 * et18_20_24i400.fm 4-1
4
4 Putting into operation
4.1 Cab/control stand
Safety instructions regarding entry and exit
Accident hazard when entering or exiting!
Entering or exiting incorrectly can cause injuries.
► Keep the mandatory climbing aids clean.
► Use the mandatory climbing aids A for entering and exiting.
► Face the machine as you enter and leave it.
► Have damaged climbing aids replaced.
Entry and exit (canopy)
Stop the machine (see chapter “Operation, stopping the machine”).
If the machine is equipped with a canopy, it can be accessed from either
side.
Entry and exit via the tracks is only possible if the travel gear is
telescopically extended (telescopic travel gear only for ET18 and
ET20).
Cab entry and exit
Stop the machine (see chapter “Operation, stopping the machine”).
When entering or leaving the cab on the left-hand side, the door
must be locked in the arrester.
Entry and exit via the tracks is only possible if the travel gear is
telescopically extended (telescopic travel gear only for ET18 and
ET20).
Fig. 50: Entry and exit (canopy)
A
A
Fig. 51: Entry and exit on left-hand side of cab
A
Putting into operation
To Next Page
Loading...
Need help?
General
