RJ-901C/RJ-900C 　 Maintenance Manual 1 Safety Instructions
1-3
1.3 Important Safety Instructions
General safety instructions that must be observed to use the equipment safely are explained below.
WARNING
• Do not place the plotter in the following areas. Doing so may result in the plotter tipping
or falling over and causing injury.
• Unstable surfaces
• Angled place
• Areas subject to vibration by other equipment
• Do not stand on or place heavy objects on your plotter. Doing so may result in the plotter
tipping or falling over and causing injury.
• Do not cover the ventilation hole of your plotter with cloth, such as a blanket or table cloth.
Doing so could obstruct ventilation and cause fire.
• Do not place the plotter in humid and dusty areas. Doing so may result in electrical shock
or fire.
• Make sure to use the power cable packed with the plotter you purchased. Not doing so
may result in electrical shock or fire.
• Make sure that the following is performed before parts replacement.
• Turn off the power of the plotter.
• Remove the power cable from the power outlet.
Not doing so may cause electric shock or damage to the electric circuit.
• Unplug the cables connected to the plotter.
Failure to do so could result in damage to the plotter.
To Next Page
Loading...
Need help?
General
