8825/8830 DDS User Guide/8
Getting to know the 8825/8830 DDS
The Scanner
DDS User Interface
Option keys and Feature keys (continued)
Output Format − Preset
Preset permits the operator to select a predefined length to which the roll
media should be cut during printing. A width may also be selected, and if the
Media Source selection is set to Auto, the system will select the roll of
media that best matches the width. If Media Source is set to R1, R2, or R3,
then the selected roll will be used regardless of the width specification.
To select the Preset mode, press the key under Output Format until the
Preset indicator illuminates. The SELECT OUTPUT FORMAT screen is
displayed.
Press the Next key or the Previous key to select an item from the list.
Press the Enter key to confirm the choice.
Note: formats may be added or removed from this list. Refer to the
References
section,
Copy Options - Media Series
and
Copy Options -
Custom Media Formats
for more information
.
Press the Exit key to leave the screen.
Output Format - Synchro
When the Synchro mode is selected, the 8825/8830 DDS measures the
length of the original as it passes through the Scanner and automatically
cuts the media at the printer to match the length of the original document.
Synchro is the factory default.
Film
Bond
Auto
R2
R3
Preset
Media Selection
Source Type
Output Format
Sheet
Synchro
Manual
R1
Vellum/
Tracing
PRESET OUTPUT FORMAT
SELECT 8.5 X 11 ANSI A
To Next Page
Loading...
Need help?
General
