8825/8830 DDS User Guide/53
Special features and making special copies
Adjusting the Margins
−
Margin Key (continued)
Margins (continued)
Press the Next key to highlight the numeric value. Press the Enter key; then
enter the new value using the numeric keypad. Press the Enter key to
confirm the choice.
The margins for the top, bottom, left, and right areas can be independently
set. The graphic image shows the approximate placement of the image as a
result of the settings. The values may be set in increments of 0.1 in. or 1.0
mm, and over a range of +4 to -4 in (+100 to -100 mm). Values outside the
allowed range are rejected.
An edge of the image may be clipped by entering a negative margin value
for that edge. In that case, the affected edge is shown as a dotted line, and
the image icon is shown as partially outside the bounds of the media.
The screen above shows a negative left margin, with TOP LEFT justification.
When all the margin values are as desired, press the Exit key to leave the
MARGINS screen.
LEAD + 1.0 IN
LEFT + 0.0 IN
RIGHT + 0.0 IN
TRAIL + 0.0 IN
LEAD + 1.0 IN
LEFT - 1.0 IN
RIGHT + 0.0 IN
TRAIL + 0.0 IN
To Next Page
Loading...
Need help?
General
