Loading paper
WorkCentre 5019/5021
User Guide
4-13
Setting the paper size
This section describes how to set the paper size and orientation for Trays 1 and 2.
After you load paper, make sure to set the size and orientation of the paper loaded into the tray.
Note You cannot change the setting while the machine is processing a job.
1. Press the Paper Supply button to select a tray where the paper you will specify the paper size and
orientation is loaded.
In the machine status diagram, the tray indicator lights up on the selected tray, and its paper size
and orientation are displayed on the paper size display.
2. Press and hold the Size (Press 2sec) button for more than 2 seconds until the paper size in the
paper size display area starts blinking.
To Next Page
Loading...
Need help?
General
