Copy
WorkCentre 5019/5021
User Guide
5-21
Erase frame
You can set to erase the black shadows created around the edge of the paper when copying with the
document cover open or copying a bound document.
You can set a value between 0 and 50 mm (in 1 mm increments) for the erase frame feature.
Notes
• The value set for erase frame applies to all four edges of the document.
• For ID card copy, erase frame is set separately.
You can set erase frame in System Administration mode. For more information, refer to Feature settings
on page 8-11.
Auto rotation
You can set the machine to rotate the scanned data when copying the document with an orientation
that differs from the orientation of the paper loaded in tray to fit onto the paper.
You can set this feature in the following cases:
• The tray selection is set to automatic.
• The zoom ratio is set to automatic.
• The zoom ratio is set to 100% and both document and paper are the same size.
Make sure to set the size and orientation of the document when using the document glass.
To Next Page
Loading...
Need help?
General
