4-5
E
FUEL
Fuel hose disconnection
WARNING
• Before checking the fuel system, remove
the battery and then remove the fuel tank
filler cap to reduce any pressure inside
the fuel tank.
• Always reduce the fuel pressure in the
fuel line before servicing the line or the
fuel pipe. If the fuel pressure is not re-
leased, pressurized fuel could spray out.
1. Disconnect:
• Quick connector
Disconnecting steps:
1. Wrap the quick connector with a cloth.
2. Spread apart the ends of the locking slider
(red plastic) 1 with your fingers as shown,
and then pull up on the slider.
NOTE:
If the quick connector is removed suddenly,
pressurized fuel could spray out. To gradually
release the fuel pressure, be sure to remove
the quick connector slowly.
3. Disconnect the quick connector 2 from
the fuel pipe 3 directly.
4. Cover the quick connector and fuel pipe
with a plastic bag 4 to protect them from
dirt.
1
2
3
4
Fuel pump module removal
1. Remove:
• Nuts
• Retainer
NOTE:
Loosen the nuts in the sequence shown.
1
4
9
6
2
3
8
7
5
BOW
Fuel tank, fuel pump module, and fuel hose
To Next Page
Loading...
Need help?
General