8-21
E
HULL
HOOD
Rivet removal
1. Remove:
• Rivets
Removal step:
1. Push in the rivet pin 1 until it clicks and is
below the top of the rivet.
2. Check:
• Rivets
Cracks/damage → Replace the rivets.
1
1
Rivet installation
1. Install:
• Rivets
Installation steps:
NOTE:
Before reinstalling a rivet, hold the rivet flange
a with both hands and push the rivet pin per-
pendicularly against a hard flat surface until
the pin protrudes from the top of the rivet.
1. Insert a rivet completely in the holes in
both the service lid 1 and inner hull 2.
2. Push in the rivet pin 3 until it clicks and is
flush with the top of the rivet.
a
3
1
2
Front hood
To Next Page
Loading...
Need help?
General