5-63
E
POWR
12. Turn the drive coupling 0 counterclock-
wise 2 turns.
NOTE:
Make sure that the camshafts turn smoothly. If
the camshafts do not turn smoothly, reinstall
camshafts. Refer to the installation steps.
0
13. Check that the portion g of the timing
chain is taut. If the timing chain is not taut,
turn the drive coupling slightly clockwise,
and then check that the timing chain is taut
again.
g
14. Position piston #1 at TDC.
Refer to “Camshaft removal.”
15. Check that the punch marks c of the cam-
shaft are aligned with the alignment marks
e on the camshaft caps. If the punch
marks are not aligned, reinstall the cam-
shafts.
e
c
Cylinder head cover installation
1. Install:
• Cylinder head cover gasket 1
• Cylinder head cover 2
NOTE:
• Apply sealant onto the locations a of the
new cylinder head cover gasket 1.
• Tighten the cylinder head cover bolts in a
crisscross pattern.
T
R
.
.
Cylinder head cover bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
LOCTITE 572
1280B
2
1
a
Camshaft
To Next Page
Loading...
Need help?
General