3-1
E
CHK
ADJ
Maintenance interval chart
The following chart should be considered strictly as a guide to general maintenance intervals.
Depending on operating conditions, the maintenance intervals should be changed.
*1: Before long-term storage
*2: Grease quantity: 33.0–35.0 cm
3
(1.12–1.18 US oz, 1.16–1.23 Imp.oz)
*3: Grease quantity: 6.0–8.0 cm
3
(0.20–0.27 US oz, 0.21–0.28 Imp.oz)
*4: After every use
MAINTENANCE INTERVAL INITIAL
THEREAFTER
EVERY
PAGE10 hours 50 hours
100
hours
100
hours
200
hours
ITEM
6
months
12
months
12
months
24
months
Spark plugs Check, clean, adjust 3-17
Lubrication points Lubricate 3-24
Internal engine
components
Lubricate
*1
50 hours or 12 months
3-23
Supercharger Lubricate 50 hours or
6 months
5-39
QSTS cables Lubricate 3-24
Intermediate housing Lubricate *2 *3 *3 3-24
Fuel system Check 3-9
Fuel tank Check, clean 3-9
Trolling speed Check 3-7
Throttle shaft Check 5-38
Cooling water passages Flush *4 —
Water inlet strainer Check, clean 3-22
Bilge strainer Clean 3-22
Electric bilge pump
strainer
Check, clean 3-23
Impeller Check 3-21
Jet thrust nozzle angle Check, adjust 3-2
Steering master Check 3-2
QSTS mechanism Check, adjust 3-4
Shift cable and reverse
gate
Check, adjust 3-7
Throttle cable Check, adjust 3-5
Stern drain plugs Check, replace 3-23
Battery Check, charge 3-19
Rubber damper Check 6-27
Engine mounts Check 5-17
Nuts and bolts Check —
Air filter element Check, replace 3-16
Engine oil Replace
50 hours or 12 months
3-14
Engine oil filter Replace 3-15
Valve clearance Check, adjust 3-10
Water separator Check *4 3-10
Maintenance interval chart
To Next Page
Loading...
Need help?
General