Yamaha WaveRunner FX SHO Service Manual

E
ELEC
– +
1
2
3
4
5
6
7
8
9
7-60
2. Push the lock button 5 or unlock button 6
to transmit the ID code from the remote
control transmitter to be registered.
NOTE:
• At this time, the system enters the registra-
tion mode to register the first code. All exist-
ing ID codes will be deleted from the remote
control receiver.
• The “UNLOCK” indicator light 7 blinks when
the registration of the ID code has been com-
pleted. (If the registration could not be com-
pleted, the “UNLOCK” indicator light comes
on. Re-transmit the ID code.)
3. After confirming that the registration of the
ID code has been completed using the
“UNLOCK” indicator light 7, transmit the
next ID code.
NOTE:
• Up to 5 remote control transmitters can be
registered in any sequence, regardless of
whether they are original equipment or addi-
tional transmitters.
• The same ID code cannot be registered
twice in the remote control receiver.
4. After ID code registration has been com-
pleted, disconnect the entry box to exit the
registration mode.
Remote control transmitter
1. Check:
• Remote control transmitter operation
Does not operate → Measure the
remote control transmitter battery volt-
age or check the remote control
receiver.
5 6
7
Remote control system

Yamaha WaveRunner FX SHO Specifications

General

Manufacturer	Yamaha
Model	WaveRunner FX SHO
Category	Personal Watercraft
Engine Type	4-cylinder, 4-stroke, Supercharged
Displacement	1812cc
Bore x Stroke	86mm x 78mm
Fuel Delivery	Electronic Fuel Injection
Horsepower	210 HP
Starter System	Electric
Lubrication System	Wet sump
Length	132.7 in (3.37 m)
Fuel Capacity	18.5 gal (70 L)
Oil Capacity	5.3 qt (5.0 L)
Rider Capacity	3 persons
Cooling System	Water-cooled
Width	1.23 m
Dry Weight	377 kg