ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 181
Interfaces
URL
Information on the destination address for the reference. It is possible to specify both IP addresses and
also domains (e.g. http://www.ABB.com
/KNX). The URL must always start with the information on the
protocol. For example "http://" for web sites or "mailto:" for e-mail addresses. The specification of the
protocol in compliance with the standards is validated and errors indicated with a red marking.
The protocols that can be used are dependent on the device used by the user and are not restricted by the
application controller.
Destination addresses with up to 600 characters are supported.
7.6.3 Sockets
The module does not have any ASM sockets and can therefore not be linked to other modules. No inputs
or outputs are displayed.
7.6.4 Group objects
No objects available
7.6.5 BACnet objects
No objects available

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English