To Next Page

To Previous Page

ABB i-bus

KNX

Operation

478 2CDC508198D0211 Rev. A | AC/S 1.x.1

10.3 Software update

The device manufacturer may make available new device software on the manufacturer's web site. This

can contain bug fixes, performance improvements and new functions.

Please regularly check for new software versions.

You will find the current version number for DCA using the "About" button on the DCA menu bar, see

chapter 6.5.6, Menu bar

For further information on updating DCA, see ETS help.

You will find the current version of the device software (firmware) on the web user interface in "Device

information" on the menu bar (see chapter 9.2.1, Menu bar) or via the ETS function "Device information".

The device software is updated via the web user interface, see chapter 7.2.3.2, Firmware update

parameter page. The device configuration is deleted during the update. Only the physical KNX address

and the IP configuration are retained. All values and states saved are lost. The configuration must be

programmed again by means of an ETS download.

You will find the current version of the ETS application program in ETS in the device properties. For further

information on updating the ETS application program, see ETS help.

10.4 Support

If you have problems with your device, support at the device manufacturer can use the following to analyze

the problem:

• ETS log files. See ETS help.

• Messages on the web user interface. See chapter 9.2.1, Menu bar.

• Monitor mode for the Automation ASM. See chapter 7.2.3.4, Monitor mode parameter page.

• Accessing the device using SSH. See chapter 7.2.3.5, SSH access parameter page.

• Device log files. See chapter 7.2.3.6, Log settings parameter page.

ABB i-bus KNX AC/S 1.x.1 Series User Manual

Questions and Answers: