ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 57
7 Parameters
7.1 General
The ETS Engineering Tool Software is always used to parameterize the device.
The KNX-related device settings are in the device's parameter window and can be changed also without
DCA installed. See chapter 7.2.1, ETS parameters.
All other device and ASM settings can be set within DCA. See chapter 7.2.2, DCA device settings for
device settings and the descriptions of the individual ASMs from chapter 7.3 for ASM settings.
General settings for the web user interface are made on the web user interface and are described in
chapter 7.2.3, Web user interface device settings
.
You will find the ASM-related settings in the web user interface in chapter 9.2, Web user interface.
The following chapters describe the parameters for the ASMs based on the parameter windows.
Parameter windows are structured dynamically so that further parameters may be enabled depending on
the parameterization and the function.
Note
The AC/S 1.2.1 is used as an example for the descriptions and screenshots. For this reason the BACnet-
related information is not relevant for the AC/S 1.1.1.
The default values of the parameters are underlined, e.g.:
Options: No

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English