ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
68 2CDC508198D0211 Rev. A | AC/S 1.x.1
7.2.3.7 SSL certificate parameter page
The data connection between the terminal device (computer, tablet,…) and the device on opening the web
user interface is, by default, not protected against access or changes by others.
Activate this function to establish a secure data connection. For this purpose the https protocol is used
instead of the http protocol. This protocol will encrypt the data connection and it will no longer be possible
for others to read and change the data. It is prerequisite for the encryption that both communication
partners (terminal device and application controller) authenticate themselves using certificates. For this
purpose both communication partners must have a certificate that the other accepts as valid.
You can create a new certificate on the device and then install it as trusted on all terminal devices to be
used to access the device's web user interface. If you do not install the certificate on the terminal devices
(browsers), then you will receive a warning that the data connection is not secure due to the lack of
authentication and it is not trusted.

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English