ABB XIO-04 User Manual

152 | XIO USER MANUAL | 2106424MNAB
7.7.4 Enable SSH/SFTP
SSH/SFTP servers require a private key for authentication. The keys are in a protected storage location in
the firmware (flash) and remain unchanged by software updates.
Customer access to the SFTP is read-only. SSH access is not available to the customer. Customers can
copy files from the XIO but cannot write or send files to the XIO.
The following folders are available to copy or download:
– Crash dumps
– Firmware: Main Totalflow application (App), factory startup (cold) configuration, and startup (cold)
configuration
– Logs: System and device loader log files
– tfData: Running (warm) configuration files
IMPORTANT NOTE:
SSH/SFTP services are disabled by default for security
. Perform this procedure
only if required and you are an advanced user. Before enabling, see
section 7 Configure security
(recommended)
or contact Technical support.
SSH/SFTP access is TCP/IP based. Enable and configure Ethernet with valid IP parameters.
Complete these steps in PCCU Expert view. Click View on the PCCU32 menu and select Expert from the
drop-down list.
To enable the SSH/SFTP services on the XIO:
Click Help to display the Services tab topic for more information to establish a read-only SFTP
connection.
8 Service and maintenance
The Service and maintenance chapter provides:
– Standard maintenance procedures, including software backup, restoration and upgrade
– Additional procedures that are required before or after a maintenance procedure
DANGER – Serious damage to health / risk to life. Do not perform maintenance when an
explosive atmosphere is present.
WARNING
– Bodily injury / Equipment damage. Remove power from the XIO if unit servicing
requires removal or disconnection of cables or wires. Failure to remove
power during service can
cause bodily injury or equipment damage. Review warnings in
Potential safety hazards.
NOTICE
– Loss of data. Collect the data and back up the configuration before performing
service on the controller. Failure to collect data and save the configuration
can result in a loss of
data and require a complete system configuration.
!

ABB XIO-04 Specifications

General

Brand	ABB
Model	XIO-04
Category	Control Unit
Language	English