ABB XIO-04 User Manual

38 | XIO USER MANUAL | 2106424MNAB
4.3 Establish local communication
Connect the laptop to the USB or Ethernet ports to establish initial local communication. These ports are
configured at the factory for local operator access. Configure PCCU to use any of these ports.
– To use USB, see section 4.3.1 Using the USB port
– To use Ethernet, see section 4.3.2 Using the Ethernet ports
IMPORTANT NOTE:
External weatherproof local communication connectors (USB or Ethernet) are
available on
XCORE enclosures, if purchased. Use external ports to connect locally if the XIO is
inside an enclosure. If the XIO is a standalone device, use the USB or Ethernet ports.
Do not use external enclosure connectors for permanent field connections. These conne
ctors are
only for local access during configuration or maintenance.
4.3.1 Using the USB port
The following instructions apply to USB port connections. Ta b le 4 -1: USB cabling provides cabling details
to connect to the USB port.
Table 4-1: USB cabling
Host system
interface type
Required cabling termination (connectors) or
adaptors
ABB part number
USB 2.0 Type A
receptacle
USB 2.0 Type mini-B plug to USB 2.0 Type A plug cable
(referred as USB PCCU32 cable)
1801800-xxx
To set up communication using the USB port:

ABB XIO-04 Specifications

General

Brand	ABB
Model	XIO-04
Category	Control Unit
Language	English