APRILIA Pegaso 650 I.E. User Manual

FUEL SUPPLY SYSTEM
4 -13
Pegaso 650 I.E.
4.8.5 AUTOMATIC TESTING
See 6.5 (IGNITION/INJECTION SYSTEM).
4.8.6 ELECTRONIC SYSTEM TROUBLESHOOTING
ACCORDING TO THE INFORMATION
PROVIDED BY THE DIAGNOSTIC WARNING
LIGHT
aWARNING
Take care around the high voltage in the ignition sys-
tem.
Never disconnect connections with the engine run-
ning.
Whenever work is performed in the ignition system,
always make sure the ignition switch is set to “1”
and the battery disconnected, unless otherwise indi-
cated (when disconnecting the battery, disconnect
the negative pole “–” first).
aCAUTION
All measurements must be taken with the compo-
nents at a temperature of 20 °C (68 °F).
General instructions regarding the elimination of
faults: as soon as the fault has been located, remove
the defective component.
4.8.7 DRIVING SHAFT POSITION SENSOR
Fault code “22”.
See 6.5.10 (CHECKING THE PICK-UP).
Release 00/2002-02
- 00

APRILIA Pegaso 650 I.E. Specifications

General

Brand	APRILIA
Model	Pegaso 650 I.E.
Category	Motorcycle
Language	English