CHASSIS
7 -8
Pegaso 650 I.E.
7.1.5 REMOVING THE REAR LUGGAGE RACK
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Remove the side panels, see 7.1.4 (REMOVING THE
RIGHT AND LEFT SIDES).
~ Unscrew and remove the screw (1).
Luggage rack side screw driving torque: 12 Nm (1.2
kgm).
â—† Unscrew and remove the screw (2).
Rear luggage rack screw driving torque: 8 Nm (0.8
kgm).
â—† Unscrew and remove the two screws (3).
Front luggage rack screw driving torque: 10 Nm (1.0
kgm).
â—† Remove the luggage rack (4) and take the bushes and
the rubber elements.
7.1.6 REMOVING THE FRONT MUDGUARD GROUP
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Position the vehicle on the stand.
aCAUTION
Handle the painted components with care and avoid
scraping or damaging them.
~ Unscrew and remove the screw (5).
Front mudguard upper screw driving torque: 7 Nm
(0.7 kgm).
aCAUTION
Upon reassembly, position the clamp (6) and the ca-
ble guide (7) correctly.
~ Unscrew and remove the screw (8).
Front mudguard lower screw driving torque: 5 Nm
(0.5 kgm).
â—† Remove the front mudguard (9).
7.1.7 REMOVING THE SADDLE
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Position the vehicle on the stand.
â—† Insert the key (10) in the saddle lock (11).
â—† Turn the key (10) clockwise and raise and remove the
saddle.
NOTE Before lowering and locking the saddle, make
sure that you have not left the key in the glove/tool kit com-
partment.
To lock the saddle:
â—† Position the tangs (12) in the seat, lower and press the
saddle, making the lock snap.
- 00
Release 00/2002-02
aWARNING
Before leaving, make sure that the saddle is properly
locked.
To Next Page
Loading...
Need help?
General
