CHASSIS
7 -66
Pegaso 650 I.E.
7.6.3 REMOVING THE REAR BRAKE DISC
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Remove the rear wheel, see 7.3.1 (REMOVING THE
REAR WHEEL).
NOTE To unscrew the screws (1), it is advisable to use
a percussion screwdriver, thanks to which it will be possi-
ble to detach the screws from the LOCTITE
®
243.
â—† Unscrew and remove the six brake disc screws (1).
aCAUTION
When reassembling, apply LOCTITE
®
243 on the
thread of the brake disc screws (1).
NOTE When reassembling, screw all the screws on
manually and tighten them in a crisscross pattern in the
following order: A-B-C-D-E-F.
Rear brake disc screw driving torque: 12 Nm (1.2
kgm).
â—† Remove the brake disc (2).
7.6.4 REMOVING THE REAR BRAKE PUMP
COMPLETE REMOVAL
â—† Drain the rear braking system, see 7.5.6 (DRAINING
THE BRAKING SYSTEMS).
aCAUTION
Handle brake fluid with care; it may chemically alter
painted surfaces and the parts in plastic, rubber, etc.
Use latex gloves.
â—† Unscrew and remove the two screws (1), taking the
bushes and the nuts.
Rear brake pump screw driving torque: 10 Nm (1.0
kgm).
â—† Remove the protection element (2).
aCAUTION
Upon reassembly, correctly position the cable (3) in
the seat (4).
â—† Unscrew and remove the rear brake pump connection
screw (5) and take the two sealing washers (6).
Rear brake pump connection screw (5) driving
torque: 20 Nm (2.0 kgm).
aCAUTION
Upon reassembly, replace the two sealing washers
with two new washers of the same type.
â—† Put a nylon bag on the coupling (7) and fix it to the
brake pipe with adhesive tape.
â—† Release the clamp (8).
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
