APRILIA Pegaso 650 I.E. User Manual

7 -15
CHASSIS
Pegaso 650 I.E.
7.1.16 REMOVING THE ELECTRIC CONTROLS ON
THE LEFT SIDE OF THE HANDLEBAR
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
◆ Position the vehicle on the stand.
◆ Turn the ignition switch to position “1”.
PARTIAL REMOVAL
NOTE The screw (1) is longer than the screw (2). Upon
reassembly, take care to position them correctly.
◆ Unscrew and remove the two screws (1) (2) fastening
the two halves of the casing (3) (4) at the bottom.
Electric controls screw driving torque: 2 Nm (0.2
kgm).
◆ Split the two halves of the casing (3) (4) apart.
aCAUTION
When reassembling, first set the lower half of the
casing (4) in place, making sure the special locating
dowel enters the relevant hole on the handlebar.
COMPLETE REMOVAL
◆ Carry out the partial removal, see above.
◆ Free the cabling from the two clamps (5) (6).
NOTE Prepare the same number of clamps, which will
be required for reassembly.
◆ Remove the dashboard fairing, see 7.1.27 (REMOV-
ING THE DASHBOARD FAIRING).
◆ Release the wiring from the fastening clamp (7).
◆ Disconnect the left-hand dip switch electric connector
(8).
aCAUTION
When reassembling, make sure the connector (8) is
plugged in properly.
◆ Remove the two halves of the casing (3) (4).
Release 00/2002-02
- 00

APRILIA Pegaso 650 I.E. Specifications

General

Brand	APRILIA
Model	Pegaso 650 I.E.
Category	Motorcycle
Language	English