CHASSIS
7 -16
Pegaso 650 I.E.
7.1.17 REMOVING THE THROTTLE GRIP
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Remove the right antivibration weight unit, see 7.1.11
(REMOVING THE ANTIVIBRATION WEIGHT).
â—† Remove the right handgrip, see 7.1.14 (REMOVING
THE HANDGRIP).
NOTE The screw (1) is longer than the screw (2). Upon
reassembly, take care to position them correctly.
â—† Unscrew and remove the two screws (1) (2) fastening
the two halves of the casing (3) (4) at the bottom.
Electric controls screw driving torque: 2 Nm (0.2
kgm).
â—† Split the two halves of the casing (3) (4) apart.
aCAUTION
When reassembling, first set the lower half of the
casing (3) in place, making sure the special locating
dowel enters the relevant hole on the handlebar.
â—† Disconnect the throttle cable (5).
â—† Pull the throttle grip (6).
7.1.18 REMOVING THE FRONT BRAKE LEVER
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
COMPLETE REMOVAL
â—† Drain the front braking system, see 7.5.6 (DRAINING
THE BRAKING SYSTEMS).
â—† Unscrew and remove the front brake lever connection
screw (7) and take the two sealing washers (8).
Front brake lever connection screw (7) driving
torque: 20 Nm (2.0 kgm).
aCAUTION
Upon reassembly, replace the two sealing washers
with two new washers of the same type.
â—† Put a nylon bag on the connection (9) and seal it with
adhesive tape.
Follow
ã
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
