7 - 55
CHASSIS
Pegaso 650 I.E.
7.3.18 INSTALLING THE REAR WHEEL
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
If the final drive unit has been removed:
â—† Put back the final drive unit, see 7.3.2 (REMOVING
THE FINAL DRIVE UNIT).
aCAUTION
Before proceeding with the reassembly, make sure
that support plate (8) of the brake caliper (9) is posi-
tioned correctly; the plate slot must be inserted in the
appropriate stop pin in the inner part of the rear fork
right rod.
Insert the disc in the brake caliper carefully.
â—† Position the wheel between the rear fork rods on the
support (1).
aWARNING
Do not introduce your fingers between the chain and
the crown gear.
â—† Make the wheel advance and position the drive chain
(6) on the crown gear (7).
â—† Uniformly apply a moderate quantity of grease on the
wheel pin (2), see 1.6 (LUBRICANT CHART).
aWARNING
Danger of injury.
Do not introduce your fingers to align the holes.
â—† Move the wheel backwards, until its central hole and
the holes on the rear fork are aligned.
â—† Rotate the support plate (8), complete with brake cali-
per (9) and with fulcrum on the stop pin, until it is
aligned with the holes.
â—† Insert the washer (5) in the wheel pin (2).
â—† Introduce the wheel pin (2) completely from the left
side.
NOTE Make sure that the wheel pin (2) is completely in-
serted.
â—† Position the washer (4) and tighten the wheel nut (3)
manually.
â—† Lock the rotation of the wheel pin (2) with the appropri-
ate key and tighten the nut (3).
Rear wheel pin driving torque: 100 Nm (10 kgm).
â—† Make sure that the following components are not dirty:
–tyre;
– wheel;
–brake disc.
aCAUTION
After reassembly, pull the rear brake lever repeatedly
and check the correct functioning of the braking sys-
tem.
Check the wheel centering.
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
