CHASSIS
7 -30
Pegaso 650 I.E.
7.1.37 REMOVING THE REAR LIGHT
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Remove the panels, see 7.1.4 (REMOVING THE
RIGHT AND LEFT SIDES).
~ Unscrew and remove the nut (1), take the washer
and if necessary the bush and the rubber element.
Rear light side screw driving torque: 10 Nm (1.0 kgm).
â—† Working under the glove compartment with a socket
spanner, unscrew and remove the nut (2) and if neces-
sary take the bushes and the rubber element.
Rear light centre screw driving torque: 10 Nm (1.0
kgm).
aCAUTION
Mark the electric connectors, in order to be able to re-
connect them correctly later on.
â—† Disconnect the electric connectors.
â—† Remove the rear light (3).
7.1.38 REMOVING THE DRIVING CHAIN
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 2.29 (DRIVE CHAIN).
â—† Remove the drive chain guards, see 7.1.29 (REMOV-
ING THE DRIVE CHAIN GUARDS).
â—† Remove the rear fork together with the wheel, the sus-
pension unit and the brake unit, see 7.9.1 (REMOVING
THE REAR FORK).
â—† Remove the drive chain (4).
aCAUTION
If the chain is considerably worn, change it together
with the drive pinion, see 7.1.40 (REMOVING THE
CHAIN ROLLERS AND SHOE) and the crown, see 7.3
(REAR WHEEL).
7.1.39 REMOVING THE DRIVE PINION
â—† Remove the drive pinion protection casing, see 3.2.3
(REMOVING THE DRIVE PINION PROTECTION
CASING).
â—† Remove the stop ring (5).
â—† Slide the drive pinion (6), complete with chain, off the
shaft.
NOTE If it is difficult to withdraw the drive pinion (6),
slacken the chain slightly, see 2.29.3 (ADJUSTING THE
DRIVING CHAIN).
â—† Remove the drive pinion (6).
NOTE When reassembling, apply Anti-Seize LOC-
TITE
®
on the inner toothing of the drive pinion (6).
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
