INTRODUCTION
0 -8
Pegaso 650 I.E.
Follow
ã
– When installing the bearings, lubricate them abundan-
tly.
– Make sure that each component has been reassem-
bled correctly.
– After a repair or periodic maintenance operation, carry
out the preliminary checks and test the vehicle in a pri-
vate area or, in any case, in a low-traffic area.
(/74/53%9/523%26)#%!.$2%0!)2
-!.5!,
0.6.1 ADVICE FOR CONSULTATION
– This manual is divided into section and chapters, each
one of which corresponds to a category of main com-
ponents.
To consult them, see the sections’ index, see page 0-1.
– If not expressly indicated otherwise, for the reassembly
of the units repeat the disassembly operations in rever-
se order.
– The terms “right” and “left” are referred to the rider sea-
ted on the vehicle in the normal riding position.
– For normal maintenance operations and for the use of
the vehicle, consult the “USE AND MAINTENANCE”
manual.
The operations preceded by this symbol must
be repeated on the opposite side of the vehi-
cle.
In this manual the various versions are indicated by the
following symbols:
e
automatic light switching version (Automatic Switch-on
Device)
m
optional
o
catalytic version
VERSION:
I
Italy
G
Greece
M
Malaysia
U
United
Kingdom
O
Holland
c
Chile
a
Austria
Y
Switzerland
H
Croatia
p
Portugal
D
Denmark
A
Australia
F
Finland
J
Japan
u
United States
of America
B
Belgium
S
Singapore
Ä
Brazil
d
Germany
s
Slovenia
R
South Africa
f
France
i
Israel
n
New Zealand
E
Spain
¬
South Korea
C
Canada