CHASSIS
7 -32
Pegaso 650 I.E.
7.1.41 REMOVING THE SIDE STAND
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Position the vehicle on the centre stand
m
, or on an
appropriate support stand fastened to the centre stand
couplings.
aCAUTION
Proceed with the stand up.
â—† Disconnect the two springs (1).
â—† Loosen and remove the nut (2), taking the washer.
Side stand nut driving torque: 30 Nm (3 kgm).
aCAUTION
Proceed with care, in order to avoid damaging the
switch (3).
â—† Unscrew and remove the screw (4).
â—† Slide out the switch (3).
â—† Slide out the pin (5).
â—† Remove the stand (6)
7.1.42 REMOVING THE CENTRE STAND
m
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Position the vehicle on the side stand.
aCAUTION
Proceed with the stand up.
â—† Disconnect the two springs (7).
~ Loosen and remove the nut (8).
~ Slide out the screw (9).
Centre stand nut/screw driving torque: 80 Nm (8
kgm).
â—† Remove the stand (10).
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
