CHASSIS
7 -14
Pegaso 650 I.E.
7.1.15 REMOVING THE CLUTCH LEVER
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
COMPLETE REMOVAL
â—† Remove the left hand guards, see 7.1.13 (REMOVING
THE HAND GUARDS).
â—† Withdraw the protection element (1).
â—† Loosen the ring nut (2).
â—† Screw the adjuster (3) completely.
â—† Make the slots (4) (5) (6) coincide.
aCAUTION
Let the engine cool down until it reaches room tem-
perature.
â—† Release the clutch cable (6) (engine side) from the cou-
pling (7).
â—† Disengage the clutch cable (8) from the clutch lever (9).
â—† Unscrew and remove the safety switch (10).
NOTE Before removing the U bolt (11), mark its posi-
tion on the handlebar so it can be refitted in the right
place.
â—† Unscrew and remove the two screws (12).
U-bolt screw driving torque: 10 Nm (1.0 kgm).
â—† Remove the U-bolt (11) (complete with rear-view mir-
ror) and take the clutch control (13).
PARTIAL REMOVAL
NOTE Before removing the U bolt (11), mark its posi-
tion on the handlebar so it can be refitted in the right
place.
â—† Unscrew and remove the two screws (12).
U-bolt screw driving torque: 10 Nm (1.0 kgm).
â—† Remove the U-bolt (11), complete with rear-view mir-
ror.
aCAUTION
Do not force pipes and cables.
â—† Partially remove the clutch control (13), complete with
hand guard.
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
