CHASSIS
7 -60
Pegaso 650 I.E.
7.5.2 CHECKING THE FRONT BRAKE DISC
For the maintenance intervals, see 2.1.1 (REGULAR
SERVICE INTERVALS CHART) under:
– Brake discs.
2.1.1 (REGULAR SERVICE INTERVALS CHART).
â—† Check the wear on the disc by measuring the minimum
thickness in several places by means of a micrometer.
If the minimum thickness is below the minimum value,
even in a single point, change the disc.
Brake disc min. thickness: 4.5 mm.
â—† Using a comparator, make sure that the maximum wob-
bling of the disc does not exceed the limit value, other-
wise change it, see 7.5.3 (REMOVING THE FRONT
BRAKE DISC).
Brake disc max. wobbling: 0.3 mm.
7.5.3 REMOVING THE FRONT BRAKE DISC
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Remove the front wheel, see 7.2.1 (REMOVING THE
FRONT WHEEL).
To unscrew the screws (1), it is advisable to use a per-
cussion screwdriver, thanks to which it will be possible to
detach the screws from the LOCTITE
®
243.
â—† Unscrew and remove the six brake disc screws (1).
aCAUTION
When reassembling, apply LOCTITE
®
243 on the
thread of the brake disc screws (1).
NOTE When reassembling, screw all the screws (1) on
manually and tighten them in a crisscross pattern in the
following order: A-B-C-D-E-F.
Front brake disc screw driving torque: 12 Nm (1.2
kgm).
â—† Remove the brake disc (2).
7.5.4 REMOVING THE FRONT BRAKE PUMP
See 7.1.18 (REMOVING THE FRONT BRAKE LEVER).
Release 00/2002-02
- 00
To Next Page
Loading...
Need help?
General
