EasyManuals Logo
Home>APRILIA>Motorcycle>Pegaso 650 I.E.

APRILIA Pegaso 650 I.E. User Manual

APRILIA Pegaso 650 I.E.
320 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #282 background imageLoading...
Page #282 background image
7 -90
CHASSIS
Pegaso 650 I.E.
7.10.3 DISASSEMBLING THE REAR SUSPENSION
LINKAGE
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 2.25.1 (REAR SUSPENSION).
â—† Remove the rear shock absorber, see 7.10.1 (REMOV-
ING THE SHOCK ABSORBER).
â—† Unscrew and remove the nuts (1) (2).
Single connection element upper nut driving torque:
50 Nm (5.0 kgm).
aCAUTION
The screw (3) on the left side of the vehicle is longer
than the screw (4) on the right side.
Upon reassembly, take care to position them correct-
ly.
â—† Unscrew the screws (3) (4), taking the washers.
â—† Remove the whole suspension linkage unit (A).
NOTE When reassembling, grease the linkage fulcrum
points, see 1.6 (LUBRICANT CHART), and be extremely
careful to refit the components correctly, making sure that
the joints move smoothly.
â—† Once reassembly is complete, check the assembly,
see 2.25.4 (CHECKING THE REAR SUSPENSION
LINKAGE).
7.10.4 DISASSEMBLING THE SUSPENSION
LINKAGE
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
â—† Remove the rear connection element unit of the sus-
pension, see 7.10.3 (DISASSEMBLING THE REAR
SUSPENSION LINKAGE).
~ Remove the oil seal (5).
~ Remove the gudgeon pin (6).
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8140180 (Kit for bearings in the range
Ø10 mm to Ø 30 mm).
~ Use a special extractor to extract the roller bearing
(7).
â—† Unscrew and remove the nut (8), taking the washer.
Single connection element lower nut driving torque:
50 Nm (5.0 kgm).
â—† Unscrew and remove the screw (9), taking the washer.
~ Retrieve the single connecting rod (10).
â—† Remove the two oil seal (11).
â—† Remove the gudgeon pin (12).
â—† Use a special extractor to extract the roller bearings
(13).
â—† Remove the two oil seal (14).
â—† Remove the gudgeon pin (15).
â—† Use a special extractor to extract the roller bearing (16).
â—† Remove the two oil seal (17).
â—† Remove the gudgeon pin (18).
â—† Use a special extractor to extract the roller bearing (19).
NOTE Wash all the components with a clean deter-
gent.
Release 00/2002-02
- 00

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APRILIA Pegaso 650 I.E. and is the answer not in the manual?

APRILIA Pegaso 650 I.E. Specifications

General IconGeneral
BrandAPRILIA
ModelPegaso 650 I.E.
CategoryMotorcycle
LanguageEnglish

Related product manuals