12. Card Cage
12.11 Replacement of the B utton module (first generation Keypad)
This proc edure assum es that t he Button assembl y is already rem oved from the Card Cage.
Necessary tools
5.5 mm nut driver
How to replace the Button module?
1. Disconnect the flat cable ( reference 1, image 1 2-17) from the Button module (reference 2, image 12-17) by performing the fol-
lowing procedure:
a) Pull out the locks at both sides of the socket (step 2, image 12-18).
b) Pull out the flat cable from the s ocket (step 3, imag e 12-18).
1
2
Image 12-17
1 2 3
Image 12-18
2. Remove the 4 lock nuts (reference 3, image 12-19) from the Button module mou nting bolts.
R5905043 DP2K-12C/11CX 19/02/2018
223
To Next Page
Loading...
Need help?
General