10. Removal and installation of projector covers
10. R EMOVAL AND INSTALLATION OF PROJECTOR
COVERS
About this chapter
Most mainten ance and servicing procedures deman d removing one or more of the projec tor covers to gain access to the parts to
maintain or to service. To avoid r edundancy, all p rocedures about cover removing or installing are group ed together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The procedur
es in this c hapter des cribe, with
detailed s tep by step actions and illustrations, how to remove or install the projector c overs . Note that some covers may only be
removed by qualified service personnel, see remarks above each procedure.
WARNING: Always switch off the p rojector and unplug the p ow er cord before removing one of the covers,
unless otherwise stated.
Overview
• Removal of the lamp c over
• Removal of the input cover
• Removal of the front cover
• Removal of the side cover
• Removal of the rear cover
• Removal of the top cover
• Open the sealed co mpartme nt
• Close the sealed c ompa rtment
• Installation of the top cover
• Installation of the rea r cover
• Installation of the side cover
• Installation of the front cover
• Installation of the input cove r
R59770351 DP2K-20C 02/02/2010
87
To Next Page
Loading...
Need help?
General