BES-940BC • BES-1240BC
137
Chapter 6 Embroidering
Grid
Displays 1 x 1 cm square grids on the background.
1. Select [Grid] from View menu and put the check mark.
Before selecting After selecting
Hoop
Displays the outline of embroidery hoop. The type of embroidery hoop can be
changed in [Load Hoop] of Settings menu.
Embroidering is allowed within the green guide in the hoop.
1. Select [Hoop] from the View menu and put a check mark.
If the hoop is not displayed, carry out the step to read the hoop. For details, refer to [Load Hoop]
( page 174).
Before selecting After selecting
Hoop position fine adjustment
Adjusts the view position of embroidery hoop.
The position can be adjusted in the range of ±20 mm in both the X and Y directions.
1. Select [Hoop position] from the View menu.
The hoop view position is stored in the hoop data. If you reinstall the program, the hoop view
position is initialized because it is overwritten.
To Next Page
Loading...
Need help?
General
