BES-940BC • BES-1240BC
143
Chapter 6 Embroidering
Setting Ranges
There are two methods for setting ranges.
Changing all ranges
1. Click [Up] to increase range. Click [Down] to reduce range.
One clicking changes the range by one level.
Changing individual range
1. Double-click the range display.
2. Click a speed range for selection.
3. Click [OK].
All ranges are reduced by
one level.
All ranges are increased by
one level.
When "S" is shown, it is under suspension.
Displays each thread
bar range.
Click here to put a check mark for pause before starting
the designated embroidering sequence.
To Next Page
Loading...
Need help?
General
