5-45
Confidential
1.4.24 Customize Code Destinations (Maintenance mode 74)
<Function>
This function customizes the machine according to settings of the language, functions, and
worker switches.
<Operating Procedure>
(1) Enter [7] and [4] in the initial stage of the maintenance mode.
The machine displays "Select 74?" on the LCD.
(2) Press [Mono Start].
The machine displays current settings on the LCD.
(3) Enter the desired customizing code.
(4) Press [Mono Start].
This saves the new setting and returns the machine to the initial stage of the
maintenance mode.
If the destination code is changed, "PLS UPDATE PROG" appears on the LCD. Load
the latest firmware (refer to Chapter 4, Section 1.3).
(5) Pressing [Stop] during the above procedure returns the machine to the initial stage of
the maintenance mode without saving the customizing code.
Note If no keys are pressed for at least one minute with any display state, the machine
automatically returns to the initial stage of the maintenance mode.
â– EEPROM customizing codes list
US Mexico Brazil Argentina Chile
DCP-J100 - 0001 0042 - 0036
DCP-J105 - 0101 0142 0136 0136
DCP-J132W-----
DCP-J152W 0001 - - 0036 0036
DCP-J172W-----
DCP-T300 - 0001 0042 0036 0036
DCP-T500W - 0001 0042 0036 0036
DCP-T700W - 0101 0142 - 0136
MFC-J200 - 0001 0042 0036 0036
MFC-J245 0001 - - - -
MFC-T800W - 0001 - - -
To Next Page
Loading...
Need help?
General