Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. (See "Loading Sheets in the Printer.")
→P.651
Because the Platen is soiled with ink or other substances, the size
of the clear film cannot be detected.
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
→P.837
Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the printer menu is On and one of the following settings
is selected.
• During
HP-GL/2 printing, GL2 Settings >Paper Source in the printer menu is
set to an option other than Automatic.
• The Media Take-up Unit is in use.
Press the Online button to resume
printing.
However, the roll paper may run
out during the print job and you
may not be able to print all of the
document.
Hold down the Stop button for a
second or more to cancel printing.
Either change the printer driver
Paper Source setting or the GL2
Settings >Paper Source setting
in the printer menu or replace the
roll with a roll that has enough pa-
per for the print job, and then try
printing again.
If you are using the Media Take-
up Unit, remove the printed docu-
ment from the Media Take-up
Unit before replacing the roll with
a roll that has enough paper for
the print job, and then try printing
again.
(See "Removing the Roll from
the Printer.") →P.634
(See "Loading Rolls in the Print-
er.") →P.628
(See "Removing Printed Docu-
ments from the Media Take-up
Unit.") →P.761
Error Message
>
Messages regarding paper
>
Insufficient paper for job iPF815
13
896
To Next Page
Loading...
Need help?
General
Weight and Dimensions
