165
3.9 Clerk Operation
There are three clerk modes as below.
Clerk Modes▶
☞ To register clerk, refer to menu code 1850 of program mode. (See chapter 2.14.6)
Assumption
- Clerk should be registered on menu 1850. (See chapter 2.14.6)
- Clerk number should be set on menu 1856 to use “V1, V2, V3, and V4”
keys (See chapter 2.14.12) If the clerk is not assigned to V1~V4, this
clerk has to enter password after pressing V key.
- All clerks can use “V” key.
* Up to 100 transactions are available in Clerk mode
* Sales data is saved in memory.
* If you press PRINT key to complete transaction, grand total price is
printed and sales data is cleared from memory.
* If you want to see total price before completing transaction, press the
ST/TTL key. To print, press the PRINT key.
* Even though you turn off the scale before printing, sales data is not cleared.
* If you want to print ticket when you log out, press V1, V2, V3 or V4 to log
on and press the PRINT key. You can also check total price by pressing
ST/TTL key after log on.
To Next Page
Loading...
Need help?
General
