Table 73. Configuration validation error (continued)
Error Description Possible cause and
recommendations
Example
missing element (cable,
risers, etc).
Comm Error A configuration element is not responding
to iDRAC using the management interface
while running an inventory check.
System management
sideband communication
Comm Error: Backplane 2
Unplug AC Power, reseat
the element and replace
the element if the problem
persists.
Error messages
This section describes the error messages that are displayed on the screen during POST or captured in the system event log
(SEL)/LifeCycle (LC) log.
Table 74. Error message HWC8010
Error code HWC8010
Message The System Configuration Check operation that is resulted in the following issue involving the indicated
component type
Arguments Riser, floating card (fPERC, adapter PERC, BOSS), backplane, processor, cable, or other components
Detailed Description The issue that is identified in the message is observed in the System Configuration Check operation.
Recommended
Response Action
Do the following and retry the operation:
1. Disconnect the input power.
2. Check for proper cable connection and component placement. If the issue persists, contact the
service provider.
Category System Health (HWC = Hardware Config)
Severity Critical
Trap/EventID 2329
Table 75. Error message HWC8011
Error code HWC8011
Message The System Configuration Check operation that is resulted in multiple issues involving the indicated
component type
Arguments Riser, floating card (fPERC, adapter PERC, BOSS), backplane, processor, cable, or other components
Detailed Description Multiple issues are observed in the System Configuration Check operation.
Recommended
Response Action
Do the following and retry the operation:
1. Disconnect the input power.
2. Check for proper cable connection and component placement. If the issue persists, contact the
service provider.
Category System Health (HWC = Hardware Config)
Severity Critical
Minimum to POST and system management configuration validation 77