AT commands Network commands
XBee/XBee-PRO® S2C ZigBee® RF Module
226
OP (Operating Extended PAN ID)
Read the 64-bit extended PAN ID. The OP value reflects the operating extended PAN ID where the
device is running. If ID > 0, OP equals ID.
Parameter range
0x01 - 0xFFFFFFFFFFFFFFFF
Default
N/A
NH (Maximum Unicast Hops)
Sets or reads the maximum number of hops across the network. This limit sets the maximum
broadcast hops value (BH) and determines the unicast timeout.
The timeout is computed as (50 * NH) + 100 ms. The default unicast timeout of 1.6 seconds (NH=0x1E)
is enough time for data and the acknowledgment to traverse approximately 8 hops.
Parameter range
0 - 0xFF
Default
0x1E
BH (Broadcast Hops)
The maximum transmission hops for broadcast data transmissions.
Parameter range
0 - 0x1E
Default
0
OI (Operating 16-bit PAN ID)
Read the 16-bit PAN ID. The OI value reflects the actual 16-bit PAN ID where the device is running.
Parameter range
0 - 0xFFFF
Default
[read-only]
NT (Node Discover Timeout)
Sets or reads the amount of time a base node waits for responses from other nodes when using the
ND (Node Discover) command. When you issue the ND command, the transmission includes the NT
value to provide all remote devices with a response timeout. Remote devices wait a random time, less
than NT, before sending their response.
To Next Page
Loading...
Need help?
General
