Regulatory information IC (Industry Canada)
XBee/XBee-PRO® S2C ZigBee® RF Module
286
n Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
n PCB Antenna (0.0 dBi)
n Monopole Whip (1.5 dBi)
IC (Industry Canada)
Labeling requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text.
For XBee ZB surface-mount:
Contains Model XBee S2C Radio, IC: 1846A-XBS2C
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
For XBee-PRO ZB surface-mount:
Contains Model PS2CSM Radio, IC: 1846A-PS2CSM
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
Note Legacy XBee-PRO SMT (Model: PRO S2C; hardware version 21xx) has IC: 1846A-XBPS2C.
For XBee ZB through-hole:
Contains Model S2CTH Radio, IC: 1846A-S2CTH
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
For XBee-PRO ZB through-hole:
Contains Model PS2CTH Radio, IC: 1846A-PS2CTH
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
Transmitters for detachable antennas
This device has been designed to operate with the antennas listed in the previous table and having a
maximum of 19 dB. Antennas not included in this list or having a gain greater than 19 dB are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
To Next Page
Loading...
Need help?
General
