AT commands Execution commands
XBee/XBee-PRO® S2C ZigBee® RF Module
256
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A
RE (Restore Defaults)
This command sets all parameters except ZS and KY to their default values. To change ZS and KY, you
must explicitly set them. In order for the default parameters to persist through subsequent resets,
send a separate WR command after RE. Read-only parameters are not directly affected by RE and
reflect the current state of the device.
Parameter range
N/A
Default
N/A
FR (Software Reset)
Resets the device. The device responds immediately with an OK and performs a reset 100 ms later.
If you issue FR while the device is in Command Mode, the reset effectively exits Command mode.
Parameter range
N/A
Default
N/A
NR (Network Reset)
Resets network layer parameters on one or more modules within a PAN. Responds immediately with
an OK then causes a network restart. The device loses all network configuration and routing
information.
If NR = 0: Resets network layer parameters on the node issuing the command.
If NR = 1: Sends broadcast transmission to reset network layer parameters on all nodes in the PAN.
Note NR and NR0 both perform the same function and may be used interchangeably.
Parameter range
0 - 1
Default
N/A
To Next Page
Loading...
Need help?
General
