Digi XBee User Manual

Regulatory information Australia (RCM)
XBee/XBee-PRO® S2C ZigBee® RF Module
288
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peutfonctionner
avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvépour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillageradioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne etson gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépassepas l'intensité nécessaire àl'établissement d'une communication
satisfaisante.
Australia (RCM)
Only XBee S2C and XBee-PRO S2C modules comply with requirements to be used in end products in
Australia and New Zealand. All products with EMC and radio communications must have registered
RCM and R-NZ marks. Registration to use the compliance mark will only be accepted from Australia or
New Zealand manufacturers or importers, or their agents.
In order to have a RCM or R-NZ mark on an end product, a company must comply with a or b below.
a. have a company presence in Australia or New Zealand.
b. have a company/distributor/agent in Australia or New Zealand that will sponsor the importing
of the end product.
Contact Digi for questions related to locating a contact in Australia and New Zealand.
ANATEL (Brazil)
The XBee ZB RF devices comply with Brazil ANATEL standards in Resolution No. 506. The following
information is required in the user manual for the product containing the radio and on the product
containing the radio (in Portuguese):
Digi Model: XB24CZ7PIS-004, XB24CZ7PISB003, XB24CZ7RIS-004, XB24CZ7RISB003, XB24CZ7UIS-004
e XB24CZ7UISB003

Digi XBee Specifications

General

Brand	Digi
Model	XBee
Category	Control Unit
Language	English