To Next Page

To Previous Page

AT commands Serial interfacing commands

XBee/XBee-PRO® S2C ZigBee® RF Module

234

value is measured in -dBm. For example, if DB returns 0x50, then the RSSI of the last packet received

was -80 dBm.

Parameter range

0 - 0xFF

Observed ranges:

XBee-PRO - 0x1A - 0x58

XBee- 0x 1A - 0x5C

Default

N/A

PP (Peak Power)

Reads the dBm output when you select maximum power (PL4).

Parameter range

0x0 - 0x12

Default

[read-only]

Serial interfacing commands

The following AT commands are serial interfacing commands.

API Enable

Enables API Mode. The device ignores this command when using SPI. API mode 1 is always used.

Parameter range

0 - 2

Parameter Description

0 API disabled (operate in Transparent mode)

1 API enabled

2 API enabled (with escaped control characters)

Default

AO (API Options)

Configure the options for API. The current options select the type of receive API frame to send out the

UART for received RF data packets.

Digi XBee User Manual

Other manuals for Digi XBee