MES1000, MES2000 Ethernet Switches 147
[gigabitethernet gi_port |
fastethernet fa_port |port-
channel group|vlan vlan_id]
[service service]
fa_port: (1..3/0/1..24);
group: (1..8);
vlan_id: (1..4094) );
service: {telnet, ssh,
snmp, http, https}
deny ip-source {ipv4-address |
ipv6_address/prefix-length}
[mask {mask| prefix-length}]
[gigabitethernet gi_port |
fastethernet fa_port |port-
channel group|
vlan vlan_id]
[service service]
Privileged EXEC mode commands
Command line request in Privileged EXEC mode appears as follows:
console#
Table 5.160 —Privileged EXEC mode commands
show management access-list
[name]
Show access control lists.
show management access-class
Show information on the active access control lists.
5.19.7 Access configuration
5.19.7.1 Telnet, SSH, HTTP and FTP
These commands are designed for switch management access server configuration. TELNET and SSH
server support by the switch allows to establish remote server connections for monitoring and
configuration purposes.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.161 —Global configuration mode commands
Telnet server is enabled by
default.
Enable remote device configuration via Telnet.
Disable remote device configuration via Telnet.
SSH server is enabled by
default.
Enable remote device configuration via SSH.
Until the encryption key is generated, SSH server will
be placed in the reserve. After the key has been
generated (with crypto key generate rsa and crypto key
generate dsa commands), server will return to the operation
mode.
Disable remote device configuration via SSH.
TCP port used by SSH server.
Restore the default value.
Public key utilization is
disabled by default.
Enable public key utilization for incoming SSH sessions.
Disable public key utilization for incoming SSH sessions.