ELTEX MES1000 User Manual

190 MES1000, MES2000 Ethernet Switches
drop | global}
- replace: replace the Option 82 content
- drop: drop packets with Option 82
Port values have a higher priority compared to the global
setting.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#
Table 5.229 —EXEC mode commands
Command
Action
show ip dhcp relay
Show the DHCP Relay agent function configuration for the switch and for interfaces
separately, and also the list of available servers.
Example execution of commands
 Show DHCP Relay agent function status:
console# show ip dhcp relay
DHCP relay is Enabled
DHCP relay is not configured on any vlan.
Servers: 192.168.16.38
Relay agent Information option is Enabled
5.29 PPPoE Intermediate Agent Configuration
The PPPoE IA function is implemented according to requirements of DSL Forum TR-101 and is
intended for use on switches on the access level.
The function allows PPPoE Discovery packets to be supplemented with the information on access
interface. This is necessary for user interface identification on the access server (BRAS, Broadband Remote
Access Server). PPPoE Active Discovery packets are controlled and intercepted globally for the entire
device and selectively for each individual interface.
Implementation of the PPPoE IA function provides additional control options for protocol messages
by assigning trusted interfaces.
Global Configuration Mode Commands
Command line request in the global configuration mode appears as follows:
console(config)#
Table 5.230—Global configuration mode commands
Command
Value/Default Value
Action
[no] pppoe
intermediate-agent
PPPoE IA is disabled by
default
Enables/disables PPPoE Intermediate Agent.
[no] pppoe
intermediate-agent
format-type access-node-id
word
word: a string of 1–32
characters
Device identifier is not
assigned by default.
A string with identifier of the access device.
The command in negative form ("no") restores the default
settings.
[no] pppoe
intermediate-agent
format-type
generic-error-message
word
word: a string of up to
128 characters
Contains the «PPPoE
Text of the error message which is displayed when the size of
the packet (MTU) sent by PPPoE IA in PADO or PADS packets is
exceeded. The command in negative form restores the default
setting.

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English