EMC Celerra User Manual

server_setup
451
The server Commands
server_setup
Manages the type and protocol component for the specified Data
Mover(s).
SYNOPSIS
server_setup {<movername> | ALL}
-type {nas | standby}
| -Load <image_name>
| -Protocol {cifs | mpfs | viruschk | rip | cdms}
{-option [start[=<n>]
| stop[,comment=<message>]
| delete]}
DESCRIPTION server_setup sets up the type and protocol component for the
specified Data Mover.
The ALL option executes the command for all of the Data Movers.
OPTIONS -type
{nas | standby}
Reboots the Data Mover as the type specified. When setting up a
standby relationship between a primary Data Mover and a standby,
make sure that the standby Data Mover has the same disk
configuration as the primary.
-Load <image_name>
Loads an image onto a Data Mover. The image may be an emergency
patch or debug image provided by EMC. Do not use this option
unless directed by EMC customer service.
-Protocol {cifs | mpfs | viruschk | rip | cdms}
Selects the protocol configuration to be managed. Multiple protocol
configurations can be enabled for a Data Mover.
Note: NFS and RIP processing are enabled by default. NFS cannot be
disabled.
-option
Specifies the following options for the specified protocol:
start
Starts the specified protocol configuration. To verify whether the
protocol configuration has started, use the respective server
command for the protocol.

EMC Celerra Specifications

General

Brand	EMC
Model	Celerra
Category	Server
Language	English