Epson ProSix S5 Series User Manual

Maintenance 11. Replacing the LED Lamp
186 S5 Rev.5
11. Replacing the LED Lamp
WARNING
■
Before
performing any replacement procedure, turn OFF the Controller and
related equipment,
and then pull out the power plug from the power source.
Performing any replacement procedure with the power ON is extremely
h
azardous and may result in
electric shock and/or malfunction of the robot
system.
■
Do not insert or pull out the motor connectors while the power to the robot system
is turned ON. Inserting or pulling out the motor connectors
with the power ON is
extremely hazardous and may result
in serious bodily injury as the Manipulator
may move abnormally, and also may result in
electric shock and/or malfunction of
the robot system.
■
Be sure to connect the AC power cable to a power receptacle. DO NOT connect
it directly to a factory power source. To shut off power
to the robot system, pull
out the power plug from the power source. Performing any work while
connecting the AC power ca
ble to a factory power source is extremely hazardous
and may result in
electric shock and/or malfunction of the robot system.
CAUTION
■
Carefully use
alcohol
, liquid gasket, and adhesive following respective
instructions
and also instructions below. Careless use of alcohol, liquid gasket,
or adhesive may cause a fire and/or safety problems.
- Never put alcohol, liquid gasket, or adhesive close to fire.
- Use alcohol, liquid gasket, or adhesive while ventilating the room.
- Wear protective gear including a mask, protective goggles, and oil-resistant
gloves.
-
If alcohol, liquid gasket, or adhesive gets on your skin, wash the area
thoroughly with soap and water.
- If alcohol, liquid gasket, or adhesive gets into your eyes or mouth, flush your
eyes or wash out your mouth with clean water thoroughly, and then see a
doctor immediately.
Name
Quantity
Note
Maintenance Parts
LED lamp
1
R13B030006

Epson ProSix S5 Series Specifications

General

Brand	Epson
Model	ProSix S5 Series
Category	Robotics
Language	English